In summer, the house is too hot and stuffy, and many people think of buying Insulated broken bridge sliding doors and windows. Insulated broken bridge sliding doors and windows can block some dust, noise and other pollution generated by the outside world. So do you know the installation method of broken bridge doors and windows? Let’s take a look at the installation method of broken bridge doors and windows.
Installation method: Mainly we need to clean the hole, and then adjust the window frame to make it on the same plane, then fix the window frame, install the glass, install the window sash, and finally carry out our gap sealing repair steps.
The first step: check the openings of doors and windows. For the same type of doors and windows and their adjacent openings up, down, left, and right, please pay attention to keeping the pull-through line, which is convenient for installation.
Step 2: When the aluminum doors and windows are connected and fixed to the wall, we should consider the force and the size of the doors and windows, and fix them with expansion screws. The screws must be driven into the glass groove or pressure line, and they should not be exposed. The screws should not be less than 1.5 meters. 1, no less than 3 small windows on each side.
Step 3: Put the aluminum door, door and window frame into the hole, and temporarily fix the door and window frame with a wooden bolt, and then press the ejected level to make it horizontally centered, and after the inner corner direction meets the requirements, fix it You can pull out the cork.
The fourth step: caulking and sealing, inject waterproof styrofoam into the gap between the door frame and the wall, leave a 10mm empty groove on the outer surface, and then pour glass glue into the empty groove to seal.
Step 5: When installing insulated broken bridge sliding doors and windows, control the rail grooves on the frame, then install the door and window sash into the frame, adjust the matching position of the fan in the frame, and fix it with structural glue. Then check whether the switch is flexible and free. On the premise that the switch is free, fix the screws (the number of screws is not less than the number of the original holes). When installing the handle, the height of the window on the same horizontal line must be adjusted. It is fixed (the number of screws is not less than the number of original holes).
Step 6: When installing the glass, pay great attention to the fact that the glass cannot be in direct contact with the glass. A wooden block (5mm) should be placed under the glass. The position of the block should be placed on the main force-bearing part. Put the glass into the door, door and window frame, And then fix it with a glass bead.
The seventh step: when the glass structural glue is applied, make it beautiful and flat, without glue overflow and glue leakage.
English
Español
العربية
