Welcome to the Hefei Analu International Trading!
Home > News > Process Steps Of Wood Grain Printing Powder Coated Aluminum Profile

Process Steps Of Wood Grain Printing Powder Coated Aluminum Profile


2020-06-05


Woodgrain printing powder coated aluminum profile means that on the basis of powder spraying or electrophoretic coating. According to the principle of high-temperature sublimation heat penetration, the wood grain pattern on the transfer paper or transfer film is quickly transferred by heating and pressing And penetrate into the profiles that have been sprayed or electrophoresed. The produced wood grain profile has clear texture, strong three-dimensional sense, and can better reflect the natural feeling of the wood grain. It is an ideal energy-saving and environmentally friendly material to replace traditional wood.

Woodgrain has strong adhesion to aluminum, non-toxic, non-odorous, and easy to clean. The product has clear and vivid lines, strong three-dimensional sense, good appearance decoration effect, and has the visual effects of returning to the original and returning to nature. The coating film on the surface of the sprayed aluminum profile is non-volatile and non-oxidizing in the air, without any pollution to the environment. The dirt deposited on the sprayed surface can be restored to its original luster and appearance once it is cleaned.

Process steps of wood grain printing powder coated aluminum profile

Process 1: Suitable for large-area or special-shaped substrates Suitable for large-area or special-shaped substrates
Step 1: Select the substrate that has been sprayed or electrophoresed.

Step 2: Wrap the transferred substrate with wood grain heat transfer paper, and fix the interface of the paper with high temperature resistant adhesive paper to prevent the wood grain heat transfer paper from loosening.

Step 3: Put a plastic bag with high-temperature resistance and good sealing on the substrate wrapped with wood grain thermal transfer paper, and then vacuum from both ends of the plastic bag until the plastic bag can Fully and effectively adhere to the substrate. The size of vacuum negative pressure should be adjusted appropriately according to the characteristics of the substrate to be transferred and the negative pressure that the plastic bag can withstand, usually between 0.3 ~ 0.8Mpa.

Step 4: Send the wrapped wood grain printing powder coated aluminum profile to the oven for baking. The level of baking temperature and the length of time should be based on the characteristics of the substrate to be transferred, the depth of the texture to be transferred, and the oven. The specific performance and other comprehensive factors should be adjusted appropriately. Generally, the transfer temperature is 160~180℃, and the time is 5~8 minutes.

Step 5: Remove the transferred substrate from the oven, pull the plastic bag from the end of the transferred substrate, tear off the thermal transfer paper, and clean the surface.

Process two: suitable for flat substrates suitable for flat substrates
Step 1: Select the substrate that has been sprayed or electrophoresed.

Step 2: Lay the front side of the wood grain thermal transfer paper and the front side of the substrate to be transferred.

Step 3: Press and heat the flat plate thermal transfer machine, usually the transfer temperature is 160~180℃, and the time is 18~25 seconds.

Step 4: Tear off the thermal transfer paper and transfer it with PET thermal transfer film.

Hefei Analu International Trading Co., Ltd.
Name * Email *
Tel Country Message *
x